·Preparing components for Installation:

·Installation of materials for the printing order – must be done before the press lights are turned on

· Review the planning schedule in Labeltraax to determine priority production of jobs.

· Update the planning board with current information on the status of the job preparation

· Check the job ticket and verify the plate number and the conformity of all related components.

· Select the appropriate plate bag from plate storage and cross reference details to ensure components are correct.

· Mount plates on to cylinders.

· Cut sticky back for cylinder

· Retrieve the right die from storage and place on cart with plate bag and cylinder.

· Install or assist with installing dies, cylinders and other components into the press.

q Removal of components:

· Assist with removing components from the press at the completion of each job

· Clean up the press and components and return material etc. to storage.

· Remove all plates with care and place in plate washer.

· Check washed plates for defects before placing into the plate bag and Jaleema folder

· Verify all plates from the job are accounted for, cleaned and returned to plate the bag with the finished rolls

· Clean if necessary, the Ink Room, the die and store them by numerical number

· Distribute clean rags to each press throughout the week

· Empties garbage on consistent basis throughout all shifts

· All other duties as assigned